STM32 SH1107驱动

【实例简介】STM32单片机SPI驱动OLED驱动芯片SH1107的驱动程序
【实例截图】
【核心代码】void OLED_Init(void)
{
GPIO_InitTypeDef  GPIO_InitStructure;

RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA , ENABLE);
 
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_0|GPIO_Pin_1;  //配置相关引脚
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;  //推挽输出
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;  //IO速度50MHz
GPIO_Init(GPIOA, &GPIO_InitStructure);
 
  
GPIO_SetBits(GPIOA,GPIO_Pin_0|GPIO_Pin_1); //PA0,PA1 输出高

delay_init();

delay_ms(500);
// OLED_CS_Clr();

OLED_WrCmd(0xAE);//--display off
OLED_WrCmd(0x02);//--set lower column address
OLED_WrCmd(0x10);//--set high column address
OLED_WrCmd(0x40);//--set start line address  Set Mapping RAM Display Start Line (0x00~0x3F)
OLED_WrCmd(0xB0);//--set page address
OLED_WrCmd(0x81);//---contract control
OLED_WrCmd(0xBF);//--128
OLED_WrCmd(0xA1);//--set segment remap
OLED_WrCmd(0xA6);//--normal / reverse
OLED_WrCmd(0xA8);//--set multiplex ratio(1 to 64)
OLED_WrCmd(0x3F);//--1/64 duty
OLED_WrCmd(0xad);//--set charge pump enable
OLED_WrCmd(0x8a);//--0x8a 外供 VCC
OLED_WrCmd(0x32);//--0X30---0X33 set VPP 8V
OLED_WrCmd(0xC8);//--Com scan direction
OLED_WrCmd(0xD3);//--set display offset
OLED_WrCmd(0x00);//--0x20
OLED_WrCmd(0xD5);//--set osc division
OLED_WrCmd(0x80);//--128
OLED_WrCmd(0xD9);//--set pre-charge period
OLED_WrCmd(0x22);//--0x22
OLED_WrCmd(0xDA);//--set COM pins
OLED_WrCmd(0x12);//--
OLED_WrCmd(0xdb);//--set vcomh
OLED_WrCmd(0x40);//--
OLED_WrCmd(0x8D);//--set DC-DC enable 
OLED_WrCmd(0x14);
OLED_WrCmd(0xAF);//--display ON
OLED_Fill(0x00);
OLED_SetPos(0,0);
OLED_WrCmd(0x8D); 
OLED_WrCmd(0x14);
}